![]() Li expects that the medical technology company will earn ($0.40) per share for the quarter. ( NASDAQ:ATEC - Get Rating) - Equities researchers at Jefferies Financial Group issued their Q3 2022 earnings per share (EPS) estimates for shares of Alphatec in a research report issued to clients and investors on Tuesday, October 11th. 7 Mid-Cap Stocks That Can be the Perfect Fit at Any TimeĪlphatec Holdings, Inc.7 Stocks to Buy to Outrun Rising Interest Rates.7 Sports Betting Stocks to Buy for Their Long-Term Possibilities.7 Water Stocks to Buy as the World Dries Up.7 Solar Stocks Leading the Clean Energy Boom.7 Railroad Stocks to Keep Your Portfolio Chugging Along.7 Agricultural Stocks to Buy to Keep Your Portfolio Well Fed.7 Streaming Stocks that Will Stand up to Streaming Fatigue.7 Cash Rich Stocks That Offer Safety in Any Market.7 Small-Cap Stocks That Could Rocket Higher in 2023.Are Investors Bailing on Travel America as Diesel Shortages Loom?.Devon Energy Lower After Beating Q3 Views But Slashing Dividend.Chesapeake Energy Focus on Natural Gas Leads to Strong Results.New Revenue Strategy, Strong Earnings, Apple Remains a Buy.Paypal Shows Promise With Strong Buy Rating.Mid-Caps CommScope, Dycom Outperform Broader Telecom Industry.Papa John’s Falls Flat On Earnings, Shares Set To Rise.Energy Transfer Raises Guidance, But Stock Lower On Revenue Miss.The Trader's Guide to Equities Research.This message disappears once the configuration requested is complete. On the AP Beacons page, notice that the AP now has an Out of Sync message beside it. Configuring an AP Beacon in Trasmit Profileįrom the Request History area, observe the status of the configuration change you requested. Select EDDYSTONE and choose one of the Profile Types, and configure the values.įigure 5.Select iBeacon and choose one of the Profile Types, and configure the values.In the Enable Transmit Profile area, you can configure this beacon. Settings area, you can enable Transmit Mode. To configure an AP Beacon in one of the transmit modes, select the MAC address of a listed AP to see further details. You can observe the AP under the Scan category. To configure an AP in the transmit mode, go to Step 4.Ĭlick on the Disabled tab, if the count is greater than zero.Ĭlick the MAC address of one of the listed APs to open a detailed view.īLE is enabled and the AP is now an AP beacon in the Scan mode.To configure an AP in the scan mode, go to Step 3.The AP Beacon categories page is displayed. Procedureįrom the Cisco Spaces dashboard, navigate to IoT Services > Device Management > Devices and then click AP Beacons. Configure AP as a Beacon to Transmit or Scan You can configure an AP as a beacon. You can also enable telemetry on the AP beacon and collect sensor information. You can also see all the APs irrespective of their configurations under All Profiles. You can configure an AP Beacon in one of the following transmit modes. You can configure these APs in either the Scan Mode or the Transmit Mode. ![]() Needs Config Change: AP's that have an error in configuration. Transmit Mode: AP beacons configured in one of the beacon transmit profiles. Scan Mode: AP beacons that are only scanning. These APs are not scanning or transmitting. IoT Services categorizes AP's according to their configurations as the following:ĭisabled: APs with BLE disabled. You can configure your access point (AP) to act as a beacon ( AP beacons) by enabling BLE on it. Configure AP as a Beacon to Transmit or Scan.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |